|
Model 3250 System Requirements
The following are required to install the Model 3250 Thermal Desorption System:
-
Agilent Model 6890/6890N/7890 Gas Chromatograph.
-
G1552A or
G3452A Split/splitless inlet with EPC (electronic pressure control).
This is normally the FRONT inlet position.
-
One (1) open
inlet position on the Model 6890 GC, or one (1) open EPC module on the 7890
GC. This is normally the REAR/BACK inlet position. The PCM
(pneumatics control module) requires an inlet EPC position for control.
-
CTC/LEAP Technologies
Re.PAL, Combi.PAL or DI.PAL autosampler. The autosampler is also
availabe as a complete/turn-key package, along with the Model 3250, from
Microanalytics. See below.
-
Cycle Composer™
or Cruise Control™ software Version 1.50
or higher. See below for a complete system.
COMPLETE TURN-KEY SYSTEMS
A complete installation package is available for
Agilent Model 6890 GCs
without inlets and/or the autosampler robotics. The Model 3250-C comes
complete with:
-
Thermal desorption system, complete with accessory
pack.
-
PCM Module for Model 6890/7890 GC.
-
RePAL robotics autosampler with liquid injection
capabilities.
-
Cruise Control/Cycle Composer software and
Chemstation drivers.
-
Installation, testing and training.
Please contact
Microanalytics for information and pricing.
Upon your purchase, the Model 3250 will be
professionally installed by a Microanalytics technical representative. All
materials necessary for immediate usage are included with the installation
packet, including the sampling and desorb/injection macros for the Cycle
Composer/Cruise Control™ software.
| 
